Sprint Pre 2

From WebOS Internals
Revision as of 22:33, 5 October 2017 by Bbito (talk | contribs) (Step 16: update with 2.2.4 scripts)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

This is the page where we document the complete Sprint Pre 2 procedure, hardware and software.

Hardware

Rich Dunbar has created a very detailed step by step pictorial guide for swapping a Sprint Pre- comms board into a Pre 2. Important note that the Sprint Comm board must be activated PRIOR to this process. Cannot activate a Sprint Comm board through the Pre 2 at this time. You should also have already read through and understand the entire software portion (Step 16 in this guide) BEFORE starting this process. Pay special attention to Step 2: Prepare Your Palm Profile.


Step 1 - Introduction

Slide1.PNG

Step 2

Slide2.PNG

Step 3

Slide3.PNG

Step 4

Slide4.PNG

Step 5

Slide5.PNG

Step 6

Slide6.PNG

Step 7

Slide7.PNG

Step 8

Slide8.PNG

Step 9

Slide9.PNG

Step 10

Slide10.PNG

Step 11

Slide11.PNG

Step 12

Slide12.PNG

Step 13

Slide13.PNG

Step 14

Slide14.PNG YOU HAVE TO BE EXTRA CAREFUL WITH THE VOLUME ROCKER RIBBON AS IT WILL BREAK IF NOT ALIGNED PROPERLY

Step 15

Slide15.PNG

Software

Step 16

Follow the instructions on WebOS_2_Upgrade and use the ./scripts/meta-sprint-franken-unlocked-pre2-2.2.4 or ./scripts/meta-sprint-franken-verizon-pre2-2.2.4 depending upon whether your Pre 2 is Unlocked or Verizon branded. See Sprint_Franken_Unlocked_Pre_2 or Sprint_Franken_Verizon_Pre_2